Table of Contents
Advertisement
5.
Remove the two 2.5 x 4 mm screws (G) and then remove the LED holder assembly (H)
from the cover assembly (Figure 4-19).
CAUTION: The thermistor contacts should be clear of the cover assembly when lifting
the LED holder assembly from the cover assembly.
6.
To remove the RTC battery (I), disconnect it from PJ1 on the LED board (PCB FT2LEx) (J)
and lift it out of the LED holder assembly.
7.
To remove the LED board, disconnect the thermistor cable (K) from PJ2 on the LED board.
Then release the four latches (L) on the LED holder assembly and remove the LED board
from the LED holder assembly (Figure 4-20).
4-22
Figure 4-19 Removing the LED holder assembly
Figure 4-20 Removing RTC battery and LED board
Hide quick links:
Advertisement
Chapters
Table of Contents
