Toshiba T2000 Maintenance Manual page 130

4. Remove the two 2.5 x 4 mm screws (F). Rotate the FL inverter board toward the LCD
module and disconnect the three cables (G) from CN1 (black connector) (H), CN2 (white
connector) (I), and CN3 (J) located on the FL inverter board (Figure 4-14).
5. To remove the LCD module, disconnect the LCD cable (K) from CN1 (L) and CN2 (M)
located on the LCD module (N) while moving the insulator (O) aside. Remove the four 2.5
x 4 mm screws (P) and remove the ground cable (Q) and LCD module from the T2000
(Figure 4-15).
To reassemble the computer, follow steps 1 through 5 in reverse order.
4-18
Figure 4-14 Removing the FL inverter board
Figure 4-15 Removing the LCD module