Cognisys STACKSHOT 3X Owner's Manual page 39

Using the slider on the left adjust the position of the rotary table to the starting point for the
stack.
You can adjust the number of steps (motor moves) by pressing the "# Steps" button and then
entering the number of steps. You can also adjust the number of degrees the rotary table
should rotate each step by pressing the "Deg/Step" button.
To adjust the direction of rotation press the "CCW" button. You can change back and forth from
"CCW" to "CW" (counter-clockwise or clockwise).
The "Preview" button will take a picture at the starting position and then at the final position to
verify your composition.
Example: Let's say we want to take a 360 degree stacked image at 10 degree intervals. That
means the rotary table would have to move 35 steps of 10 degrees. Why 35 and not 36? The
stack starts at 0 degrees (which is the same as 360 degrees). If we set the rotation to rotate 360
degrees there would be duplicates at 0/360 degrees.
Here is the process:
Change the number of steps to 35:
Change the degrees per step to 10:
39