Cognisys STACKSHOT 3X Owner's Manual page 130

Motor "squealing" when not
moving.
Camera takes multiple
pictures per step
Need to restore factory
settings
If you cannot resolve a problem with StackShot 3X, please contact us at
inc.com. We want to make sure that you are completely satisfied!
Torque setting too low for
your load.
High Precision option is
enabled
# pics set to greater than one
Camera in continuous mode
Operator Error -- you did
something bad!
130
and to the motorized device.
Increase the motor torque
setting. See section "9.6 -
Torque".
See section "9.7 High-
Precision" for turning high
precision mode off.
See sections "8.5 - Shutter
Output Settings" for changing
the number of pictures taken
to "1".
StackShot 3X defaults to a
500ms shutter press. Make
sure the camera is in single-
shot mode otherwise you may
get more than one picture.
With StackShot 3X powered
off, press and hold the power
button until the red power
light goes out. Release the
power button. Optionally you
can load the defaults from the
settings page. See section
"8.3.3 - Load Factory
Defaults".
support@cognisys-