18
Mojito MAX input and output descriptions
This section describes the inputs and outputs available on the Matrox Mojito
MAX card and I/O cable.
Inputs
This section describes the inputs that are available on the Mojito MAX card and
I/O cable. For a list of the supported input and capture formats, see
"Matrox Mojito MAX Supported Input and Capture
Matrox Mojito MAX card
• HDMI IN
(either YUV or RGB), and up to eight channels of uncompressed embedded
audio, from a digital HDMI device. HDCP sources and SD video are not
supported on this input. Connect an HDMI video/audio cable from a camera,
VTR, or other video input source.
• SDI IN Provides an input for use with a digital SDI device. This input
supports HD-SDI and SD-SDI video, and up to eight channels of embedded
audio. Connect an SDI video/audio cable from a camera, VTR, or other
video input source.
Matrox Mojito MAX I/O cable
• REF IN Allows you to genlock all devices connected to your Mojito MAX
system to an external genlock source (bi-level analog black burst for SD, or
analog tri-level sync for HD).
To compensate for cable delays, timing-offset controls that align your video
output relative to your external genlock source are available (see
your genlock settings"
• Y, Pb, and Pr IN (Component video) Provide inputs for use with an
analog component device, and support HD and SD video. Connect
component Y, Pb, Pr video cables from a camera, VTR, or other video input
source.
¦ Note
component input.
• Pb/Y and Pr/C IN (S-Video) Input connectors Pb/Y and Pr/C allow you
to connect an S-Video adapter cable (two male BNC to S-Video) for use with
an analog S-Video device (SD only). Connect an S-Video cable, via an
S-Video adapter cable, from a camera, VTR, or other video input source. For
instructions on how to connect S-Video devices to Mojito MAX, see
"Connecting S-Video devices to Mojito MAX"
¦ Note
Chapter 3, Connecting External Devices to Matrox Mojito MAX
Provides a Type C HDMI socket input for HD HDMI video
on page 142).
The CVBS and S-Video inputs are not available when using the
The component input is not available when using the S-Video input.
Appendix B,
Formats."
"Specifying
on page 14.