Performance; Analog Input - Matrox Solios Series Installation And Hardware Reference

Configuration
Asynchronous video sources supported
1 1 4-tap video source
2 1 3-tap video source (RGB) and 1 1-tap video source
3 2 2-tap video sources
4 1 2-tap video source and
2 1-tap video sources
5 1 2-tap video source and
2 1-tap video sources
6 4 1-tap video sources
1. Note that taps expected to come from the same video source can also come from different video sources as long as they are synchronized (genlocked). In this case,
the grabbed data is stored in separate color bands of the same buffer; the buffer can be in planar format.
2. Note that Matrox Solios eA/XA Single only has acquisition path 0 and can therefore support only 1 tap. Matrox Solios eA/XA Dual only has acquisition paths 0 and 1,
and can only support two taps.

Performance

The video timing parameters supported by the board are as follows:
Number of pixels / line (including sync and blanking)
Number of lines / frame (including sync and blanking)
Pixel clock for single sampling rate operation
Bandwidth
eA/XA Single
eA/XA Dual
eA/XA Quad
Analog bandwidth (-3 db cutoff frequency)

Analog input

Matrox Solios eA/XA includes the electronic circuitry needed to select, amplify,
filter, and drive the video signal prior to sending it to the analog-to-digital (A/D)
converters.
Matrox Solios eA/XA Quad has four wide-band analog acquisition paths, Matrox
Solios eA/XA Dual has two, whereas Matrox Solios eA/XA Single has one. The
following table describes the video source combinations from which simultaneous,
independent acquisition is supported and the acquisition paths to which they must
be connected:
1
Matrox Solios eA/XA acquisition section
Maximum
64 K
64 K
65 MHz
130 Mbytes/sec
260 Mbytes/sec
520 Mbytes/sec
100 MHz
Acquisition path
0 1
4-tap
3-tap
2-tap
2-tap
1-tap 1-tap
1-tap 1-tap
73
2
2 3
1-tap
2-tap
1-tap 1-tap
2-tap
1-tap 1-tap