How To Wind The Lower Thread; Adjusting The Height Of The Presser Foot; Disposing The Waste Oil - SunStar SPS/B-1306 SERIES User Manual

7) How to Wind the Lower Thread

A. Insert the bobbin into thread winding drive shaft ② on thread winding base ① which is installed on the upper top.
B. Operate the machine after sticking the thread winding lever ③ to the bobbin.
C. When the thread winding lever is separated from the bobbin, cut the bobbin thread with thread winding mes ④.

8) Adjusting the Height of the Presser Foot

A. Unfasten presser foot screw ① with the needle bar at
the lowest position.
B. Adjust the height so that the presser foot bottom
comes 0.5mm(the thickness of the thread used)
above the sewing material. Then, tighten the screw.
[ Caution ]
After adjusting the height of presser foot, confirm
the position of wiper.
· Too excessive gap can cause jumping.
· Insufficient gap can cause a failure in thread
adjustment.

9) Disposing the Waste Oil

When the oil receiving oiler at the bottom of the table is
full, take it off to empty.
[ Caution ]
Spread out some fabrics or papers on the floor
when you attach or remove the oil receiving
container.
24
Bobbin
②
④
③
①
①
0.5mm
[ Fig. 29 ]
[ Fig. 30 ]
Oiler
[ Fig. 31 ]