Sleep Timer Setup - Blaupunkt PP15DAB Owner's Manual

PP15DAB
NOTE:
· Depending on the device manufacturer, you need to perform the registration (PAIRING)
again to connect the devices
· The Bluetooth compatibility cannot be ensured for devices (e.g. mobile phones) getting
released in the future.
· To ensure an optimal connection, make sure that the battery of your player is completely
charged.
· Some of the mobile phone brands have an energy-saving mode. Deactivate the energy-
saving mode as it can otherwise result in problems during the data transfer through
Bluetooth.
· To be able to transfer audio data, Bluetooth needs to stay activated in your player
Observe the operation manual of your player.
· If a mobile phone on which you are playing music receives a call, the music will be
interrupted. The sound however is not played back via the speaker. After you have ended
the call, the devices are connected to each other again and playback continues. The
volume increases slowly.
Using The unit as a Handsfree Bluetooth Speakerphone
1. Link your cell phone to the speaker via Bluetooth as described above .
/ OK button on the
2. When receiving an incoming call on your cell phone, short tap the
unit to switch the incoming call from cell phone to the speaker. A short beep sound will be
heard confirming the call was answered. Complete your call using the built-in
microphone and speaker.
3. Adjust the volume control of your cell phone to obtain the desired sound level.
/ OK button agin, a short beep sound will be heard and
4. To end the call, just tap the
the call will end. If you were playing music from your cell phone to the speaker before
answering the call, the music will automatically resume playing when you hang up.
5. To ignore an incoming call, simply tap the /OK button three times continuously, a
beep sound will be heard and the call will be ignored.

Sleep Timer Setup

- During operating mode, press the Zz button to set and adjust the sleep delay time in
minutes from: "Sleep off /1/20/30/60/90/120", the sleep icon " " flashes on the display.
- Press the OK button to confirm the setting, the sleep icon " " will stop flashing.
- Select "Sleep off " to cancel the sleep mode, the sleep icon " " disappears
simultaneously.
- When the sleep timer is active, press the Zz button to show the current sleep time, press
it again to modify the setting.
19