Enabling Logging; Configuring Simple Network Time Protocol - Avaya 4000 Series Quick Start Configuration

Configuring the switch using ACLI
Variable
<community-string>

Enabling logging

Use this procedure to enable the logging of system messages. For more information about logging,
see Avaya Ethernet Routing Switch 2000, 3000, 4000, 5000 Series and Virtual Services Platform
7000 Series Logs Reference, NN47216–600.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. To enable system logging, enter the following command at the command prompt:
logging remote level informational

Configuring Simple Network Time Protocol

The Simple Network Time Protocol (SNTP) feature synchronizes the Universal Coordinated Time
(UTC) to an accuracy within 1 second. This feature adheres to the IEEE RFC 2030 (MIB is the
s5agent). With this feature, the system can obtain the time from any RFC 2030-compliant NTP/
SNTP server.
For more information on SNTP, see Configuring Systems on Avaya Ethernet Routing Switch 4000
Series, NN47205–500.
About this task
Use this procedure to configure the Network Time Protocol (NTP) servers for SNTP.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. Enter the following command to configure the SNTP server primary IP address:
sntp server primary address [<A.B.C.D> |
<primary_server_ipv6address>]
Quick Start Configuration for Avaya ERS 4000 Series
30
Definition
If you are using the proprietary method for SNMP,
enter a community string that works as a password
and permits access to the SNMP protocol.
Comments? infodev@avaya.com
June 2014