Configuring The Terminal - Avaya 4000 Series Quick Start Configuration

Configuring the terminal

You can configure the switch terminal settings to suit your preferences for the terminal speed and
display.
About this task
Use the following procedure to configure terminal settings including the terminal connection speed,
and number of characters in the terminal display width and length.
Important:
After you modify the terminal configuration, the new settings are applied to the current active
session and to all future sessions (serial, telnet or SSH). Terminal configuration change does
not affect open concurrent sessions.
Procedure
1. Log on to ACLI to enter User EXEC mode.
2. At the command prompt, enter the following command:
terminal {length <0-132> | width <1-132>}
3. To display the current serial port information, enter the following command:
show terminal
Variable definitions
Use the data in the following table to use the terminal command.
Variable
length
width
June 2014
Definition
Set the length of the terminal display in lines. By
default, 23 lines are displayed.
Important:
If you set the terminal length to 0, the pagination
is disabled and the display scrolls continuously.
Set the width of the terminal display in characters. By
default, 79 characters are displayed.
Quick Start Configuration for Avaya ERS 4000 Series
Comments? infodev@avaya.com
Configuring the terminal
19