Displaying Local Alarms - Avaya 4000 Series Quick Start Configuration

Variable definitions
Use the data in the following table to use the show boot command.
Variable
diag
image
Important:
When the currently loaded and operational software status is displayed for a stack, the unit
number is replaced by the word All.

Displaying local alarms

You can view local alarms to monitor alarm conditions.
Local alarms are raised and cleared by applications running on the switch. Local alarms are an
automatic mechanism run by the system and do not require any additional user configuration. The
raising and clearing of local alarms also creates a log entry for each event. Check alarms
occasionally to ensure no alarms require additional operator attention.
About this task
Use this procedure to display local alarms.
Procedure
1. Enter Global Configuration mode:
enable
configure terminal
2. At the command prompt, enter the following command :
show rmon alarm
June 2014
Definition
Display only information for the agent load.
Display only information for the image load.
Quick Start Configuration for Avaya ERS 4000 Series
Comments? infodev@avaya.com
Displaying local alarms
49