Modbus/Tcp Mapping - Advantage EKI-5000 Series User Manual

Setting PoE
1. Select the device to configure by clicking on it.
2. In the Configuration Area, select the PoE tab.
3. Select the radio-box next to the target port then click on it to check and enable the PoE
function on that port. To disable the PoE function on the port, click on the radio-box to
unselect it.
4. Click Refresh to update the PoE status for each port. Each port displays the current
enabled or disabled state in addition to the following information.
Voltage (V)

Current (mA)

Power (W)

Temperature (Celsius)


4.2. Modbus/TCP Mapping

The data map addresses of Advantech switches shown in the following table start from
Modbus address 30001 for function code 4.
Figure 4-12. Setting Modbus/TCP Idle Time
M S
ANAGING WITCH
70