Related Manuals for Advantage VSX41
Summary of Contents for Advantage VSX41
- Page 1 VSX41 Video Switcher Operation Manual ® Biamp Systems, 10074 S.W. Arctic Drive, Beaverton, Oregon 97005 U.S.A. (503) 641-7287 http://www.biamp.com an affiliate of Rauland-Borg Corp.
- Page 2 blank print update Dec 9/99...
-
Page 3: Table Of Contents
Passive Rear Panel pg. 3 switching allows the VSX41 to be used as either a switcher or router, and for either video or audio signals. The VSX41 is designed to operate independently pg. 4... -
Page 4: Front Panel
Only one input can be selected at a time. If power is lost or turned off, Channel Select reverts to Input 1 when power returns. The VSX41 may be used as a "router", with a single input signal being switched to one of four outputs (see Applications on page 9). The VSX41 may be used with either video or audio signals. -
Page 5: Rear Panel
(+) to tip and (ground) to sleeve. However, if all audio signals to be connected are balanced, they may be wired with (+) to tip and (-) to sleeve (the input/output grounds are connected directly, bypassing the VSX41). The VSX41 may also be used as a 1-in/4-out video (or audio) "router", with a single input being switched to one of four outputs (see Applications on page 9). -
Page 6: Remote Control
VSX41. Remote controls may be added at any CHANNEL SELECT time, and do not require the VSX41 to be modified, opened, or removed from a rack. There are four remote control devices: a hand-held Infrared Transmitter, an Infrared Receiver unit, a wall-mount push- button Controller with status indicators &... - Page 7 Input 2 overrides Logic Inputs 3 & 4, and Logic Input 3 overrides Logic Input 4). For example, if Logic Input 2 is turned on (Channel 2 selected) and then Logic Input 1 is also turned on, the VSX41 will switch to Channel 1. However, if Logic Input 2 is turned on (Channel 2 selected) and then Logic Input 3 is also turned on, the VSX41 will not switch channels.
-
Page 8: Options
AGII or DRC4+4, internal jumpers allow VSX41 Logic Inputs to be assigned to corresponding pins for those products (refer to AGII & DRC4+4 manuals). To assign Logic Input pins, move the "SOURCE SELECT" jumper straps (J2) to the desired Logic Input Pin Number positions (see diagram below). -
Page 9: Applications
MUTE CHANNEL SELECT MAIN LEVEL This diagram shows a VSX41 used for video source selection in a "sports bar" application. A similar system could be used for classroom ® applications. The VSX41 Remote Output is connected to an ADVANTAGE SPM412e Remote input, allowing combined control of the two units. - Page 10 "member" camera has priority over the "room" camera. The "room" camera can be made to come on whenever no one is speaking, by wiring the VSX41 Logic Input 4 directly to ground. Manual or automatic audio override can also be assigned to channel 1 of the autoONE...
- Page 11 2 input on the four CMA60s. The VSX41 provides four outputs, which are sent to the Channel 1 input on the four CMA60s. (When using the VSX41 as a "router", the Input connectors are used as the four outputs.) Paging signal is routed to a specific zone via the VSX41 front panel Channel Select switches or by remote switches connected to the VSX41 Logic Inputs.
- Page 12 SPECIFICATIONS Maximum Input/Output Voltage: 20Vrms Maximum Input/Output Current: 100mA rms Remote Translator: maximum input voltage +15VDC minimum input voltage -15VDC switching threshold +2VDC input voltage when idle (high input) high ( > +2VDC) input voltage when idle (low input) low ( < +2VDC) Crosstalk (20Hz ~ 20kHz): -70dB Power Requirements:...
-
Page 13: Block Diagram
BLOCK DIAGRAM Advantage VSX41 Block Diagram relay 1 3.9k input 1 output (RCA & BNC) (RCA & BNC) relay 2 3.9k input 2 (RCA & BNC) relay 3 3.9k input 3 (RCA & BNC) relay 4 3.9k input 4 (RCA & BNC) -
Page 14: Warranty
WARRANTY BIAMP SYSTEMS IS PLEASED TO EXTEND THE FOLLOWING 5-YEAR LIMITED WARRANTY TO THE ORIGINAL PURCHASER OF THE PROFESSIONAL SOUND EQUIPMENT DESCRIBED IN THIS MANUAL. BIAMP Systems expressly warrants this product to be 4. BIAMP SYSTEMS SHALL NOT IN ANY EVENT BE free from defects in material and workmanship for a LIABLE SPECIAL,...