Table of Contents
Advertisement
S
I
WITCH
NSTALLATION
Removing the DIN-Rail Mounting Kit
1. Push the switch down to free the bottom of the plate from the DIN rail.
2. Rotate the bottom of the device towards you and away from the DIN rail.
3. Once the bottom is clear of the DIN rail, lift the device straight up to unhook it from the
DIN rail.
\
2.3.2 Wall-Mounting
The wall mounting option provides better shock and vibration resistance than the DIN rail
vertical mount.
When installing, make sure to allow for enough space to properly install the cabling.
Before the device can be mounted on a wall, you will need to remove the DIN rail plate.
1. Rotate the device to the rear side and locate the DIN mounting plate.
2. Remove the screws securing the DIN mounting plate to the rear panel of the switch.
3. Remove the DIN mounting plate. Store the DIN mounting plate and provided screws for
later use.
4. Align the wall mounting plates on the rear side. The screw holes on the device and the
mounting plates must be aligned, see the following illustration.
37
Figure 2-2. Removing the DIN-Rail
1
DIN Rail
2
Advertisement
Table of Contents
