Safety Instructions - Advantage EKI-5000 Series User Manual

ATEX Information
ATEX Directive 94/9/EC (as amended relating to Group II, Category 3 locations)
Standard: EN 60079-0:2012+A11:2013; EN 60079-15:2010
Conditions of safe use:
The equipment shall only be used in an area of not more than pollution degree 2, as

defined in IEC 60664-1.
The equipment shall be installed in an enclosure that provides a degree of protection

not less than IP 54 in accordance with EN 60079-15 and accessible only by the use of a
tool.
Transient protection shall be provided that is set at a level not exceeding 140 % of the

peak rated voltage value at the supply terminals to the equipment.

Safety Instructions

Read these safety instructions carefully.

Keep this user manual for later reference.

Disconnect this equipment from any AC outlet before cleaning. Use damp cloth. Do not

use liquid or spray detergents for cleaning.
For plug-in equipment, the power outlet socket must be located near the equipment and

must be easily accessible.
Keep this equipment away from humidity.

Put this equipment on a reliable surface during installation. Dropping it or letting it fall

may cause danage.
The openings on the enclosure are fo air convection. Protect the equipment from over-

heating. DO NOT COVER THE OPENINGS.
Make sure the voltage of the power source is correct before connecting the equipment

to the power outlet.
Position the power cord so that people cannot step on it. Do not place anything over the

power cord.
All cautions and warning on the equipment should be noted.

If the equipment is not used for a long time, disconnect it from the power source to avoid

damage by transient over voltage.
Never pour any liquid into an opening. This may cause fire or electrical shock.

Never open the equipment. For safety reasons, the equipment should be opened only

by qualified service personnel.
II 3G
iv