Advantage EKI-5000 Series User Manual page 47

5. Secure the wall mount plates with M3 screws, see the following figure.
Once the wall mounting plates are secure on the device, you will need to attach the wall
screws (x3).
6. Locate the installation site and place the switch against the wall, making sure it is the
final installation location.
7. Use the wall mount plates as a guide to mark the locations of the screw holes.
8. Drill four holes over the four marked locations on the wall, keeping in mind that the holes
must accommodate wall sinks in addition to the screws.
9. Insert the wall sinks into the walls.
10. Insert the screws into the wall sinks. Leave a 2 mm gap between the wall and the screw
head to allow for wall mount plate insertion.
4.5 mm
3.0 mm
Figure 2-4. Securing Wall Mounting Screws
Make sure the screws dimensions are suitable for use with the wall mounting plate.

Do not completely tighten the screws into the wall. A final adjustment may be needed

before fully securing the wall mounting plates on the wall.
11. Align the wall mount plate over the screws on the wall.
Figure 2-3. Installing Wall Mount Plates
S
WITCH
2.0 mm
I
NSTALLATION
38