Combination Switch - Mercedes-Benz CLS 2015 Operator's Manual

Exterior lighting
124
To switch on the standing lamps: the
X
SmartKey is not in the ignition lock or it is in
position 0.
Turn the light switch to W (left-hand side
X
of the vehicle) or X (right-hand side of
the vehicle).

Combination switch

Turn signal
High-beam headlamps
:
Turn signal, right
;
High-beam flasher
=
Turn signal, left
?
To indicate briefly: press the combination
X
switch briefly to the pressure point in the
direction of arrow ; or ?.
The corresponding turn signal flashes three
times.
To indicate: press the combination switch
X
beyond the pressure point in the direction
of arrow ; or ?.
High-beam headlamps
To switch on manually: turn the Smart-
X
Key to position 2 in the ignition lock or start
the engine.
Vehicles without Adaptive Highbeam
X
Assist: turn the light switch to L or
Ã.
Vehicles with Adaptive Highbeam Assist:
X
turn the light switch to L.
Press the combination switch beyond the
X
pressure point in the direction of arrow :.
In the à position, the high-beam head-
lamps are only switched on when it is dark
and the engine is running.
The blue K indicator lamp in the instru-
ment cluster lights up when the high-beam
headlamps are switched on.
To deactivate: move the combination
X
switch back to its normal position.
The blue K indicator lamp in the instru-
ment cluster goes out.
Vehicles with Adaptive Highbeam Assist:
when Adaptive Highbeam Assist is active, it
automatically controls activation of the high-
beam headlamps ( page 125).
Y
High-beam flasher
To switch on: turn the SmartKey in the
X
ignition lock to position 1 or 2, or start the
engine.
Pull the combination switch in the direction
X
of arrow =.
Hazard warning lamps
To switch on the hazard warning lamps:
X
press button :.
All turn signals flash. If you now switch on a
turn signal using the combination switch,
only the turn signal lamp on the corre-
sponding side of the vehicle will flash.
To switch off the hazard warning lamps:
X
press button :.