Combination Switch - Mercedes-Benz 300 SDL turbo 126 D Owner's Manual

Combination Switch

1 Low beam (with exterior lamp
switch turned to position 2)
2 High beam (with exterior lamp
switch turned to position 2)
3 High beam flasher (high beam
available independent of exterior
lamp switch position)
4 Turn signals, right
5 Turn signals, left
42
To operate the turn signals, move the
combination switch past the point of
resistance (up or down). The switch is
automatically cancelled when the
steering wheel is turned to a large
enough degree.
To signal minor directional changes,
such as changing lanes on a highway,
move combination switch to the point
of resistance and hold it there.
6 Control for
• windshield washer system
• headlamp cleaning system
(will work only with exterior
lamp switch in position 1 or 2).
When the washer system is acti­
vated, the wipers also operate for
a limited time.
The windshield washer nozzles
are automatically heated.
7 Windshield wiper control
0 Wiper off
1 Intermittent wiping
II Normal wiper speed
III Fast wiper speed
Note:
If one of the turn signals fails, the turn
signal indicator system flashes and
sounds at a faster rate than normal. In
addition, the lamp failure indicator will
come on.
For the overload protection of the
windshield wiper motor, see page 79.