Tires/Wheels - Mercedes-Benz CLS 2015 Operator's Manual

Wheel and tire combinations
372
Turn the crank of the jack counter-clock-
X
wise until the vehicle is once again standing
firmly on the ground.
Place the jack to one side.
X
Tighten the wheel bolts evenly in a cross-
X
wise pattern in the sequence indicated (:
to A). The specified tightening torque is
96 lb-ft (130 Nm).
Turn the jack back to its initial position.
X
Stow the jack and the rest of the vehicle
X
tools in the trunk again.
Check the tire pressure of the newly moun-
X
ted wheel and adjust it if necessary.
Observe the recommended tire pressure
( page 348).
Y
i Vehicles with tire pressure monitor: all
wheels mounted must be equipped with
functioning sensors.
Wheel and tire combinations
General notes
! For safety reasons, Mercedes-Benz rec-
ommends that you only use tires and
wheels which have been approved by
Mercedes-Benz specifically for your vehi-
cle.
These tires have been specially adapted for
use with the control systems, such as ABS
®
or ESP , and are marked as follows:
MO = Mercedes-Benz Original
R
MOE = Mercedes-Benz Original Extended
R
(tires featuring run-flat characteristics)
MO1 = Mercedes-Benz Original (only cer-
R
tain AMG tires)
Mercedes-Benz Original Extended tires
may only be used on wheels that have been
specifically approved by Mercedes-Benz.
Only use tires, wheels or accessories tes-
ted and approved by Mercedes-Benz. Cer-
tain characteristics, e.g. handling, vehicle
noise emissions or fuel consumption, may
otherwise be adversely affected. In addi-
tion, when driving with a load, tire dimen-
sion variations could cause the tires to
come into contact with the bodywork and
axle components. This could result in dam-
age to the tires or the vehicle.
Mercedes-Benz accepts no liability for
damage resulting from the use of tires,
wheels or accessories other than those tes-
ted and approved.
Information on tires, wheels and approved
combinations can be obtained from any
qualified specialist workshop.
Overview of abbreviations used in the follow-
ing tire tables:
BA: both axles
R
FA: front axle
R
RA: rear axle
R
The recommended pressures for various
operating conditions can be found:
on the Tire and Loading Information placard
R
with the recommended tire pressures on
the B-pillar on the driver's side
in the tire pressure table on the inside of the
R
fuel filler flap
Observe the notes on recommended tire
pressures under various operating conditions
( page 348).
Y