Toshiba e-studio 2330c Imaging Manual page 80

(4) Enter adjustment mode [05]. Change the values for codes [1630 to 1633] to adjust the maximum color
density of text.
Color to adjust [05] code
Y
05-1630
(Yellow)
M
05-1631
(Magenta)
C
05-1632
(Cyan)
K
05-1633
(Black)
* Set the value in increment of 1, while checking the copy image until the optimum value is obtained.
After adjusting the maximum color density of the text, copy and check the copy image quality.
If further image quality adjustments are still necessary, use the next procedure.
(5) Enter adjustment mode [05]. Change the values for codes [1725] and [7841] to adjust the level of
reproducibility in the Text/Photo mode or the User custom mode.
Color mode
Full color
* Set the value in increment of 1, while checking the copy image until the optimum value is obtained.
First, set "3" for this code and check the copy image. If further image quality improvements are still
necessary, set "2." If even further improvements are still necessary, set "1" for this code.
* Remember that if a value larger than "3" is set, the edges of the image are enhanced (attaching importance
to the reproducibility of text). The table below shows you the correlation between the value and image
quality.
Value
0 Default
Intended to improve the reproducibility of photos
1
more than the one obtained when "2" is set.
Intended to improve the reproducibility of photos
2
more than the one obtained when "3" is set.
Equivalent to the one obtained when the default
3
value ("0") is set.
Intended to improve the reproducibility of text more
4
than the one obtained when "3" is set.
Intended to improve the reproducibility of text more
5
than the one obtained when "4" is set.
* For the User custom mode, refer to step (1) in "2.8 To Eliminate Moiré".
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
Recommended value
Set a value larger than 5 to
increase the density.
Set a value smaller than 5 to
decrease the density.
Original mode [05] code
Text/Photo 05-1725
User custom 05-7841
Advantage of image quality
2-45
2. Copier-specific Adjustments
Acceptable
Default
value range
0 to 10
Recommended
value
Set a value smaller than
3.
Reproducibility of edges
Intermediate
Soft
↓
Intermediate
↓
Sharp
© 2008 TOSHIBA TEC CORPORATION All rights reserved
5
Accept
able
Default
value
range
0 to 5 0