Toshiba e-studio 2330c Imaging Manual page 43

2. Copier-specific Adjustments
(4) Enter the adjustment mode [05] and adjust the gamma balance in each of medium- and high-density areas.
Original mode
Text/Photo
Text
Photo
ACS / Black
Text/Photo
ACS / Black
Text
ACS / Black
Photo
Subcode
1
2
* Set the value in increments of approximately 20, while checking the copy image until the optimum value is
obtained. Note that gradations (density level) in the medium- and high-density areas may be reversed with
some setting values.
* Subcodes to be entered differ depending on the target density area. Refer to the table above to enter the
subcode for the area to be adjusted. The density of thin text or illustrations is changed by adjusting mainly
the setting value for the medium- or high-density area. Do not change the setting value for the low-density
area because if the subcode is set at "0", the density of the low-density area is adjusted but there is little or
no effect on changing the density of thin text or illustrations.
After setting the value, copy and check the image quality.
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
[05] code Subcode
05-590
05-591
05-592
05-7957
1/2
05-7958
05-7959
Area where the density
is adjusted
Medium-density area
High-density area
2-8
Recommende Acceptable
d value value range
Set a value larger
0 to 255
than 128.
© 2008 TOSHIBA TEC CORPORATION All rights reserved
Default
128