Toshiba e-studio 2330c Imaging Manual page 114

To adjust gamma balance
* This adjustment is effective when you change the gamma balance of the copied image.
(a) Enter the adjustment mode [05]. Change the values for the codes [7980] to [7983] to adjust the
gamma balance of each color.
Adjustme
nt
Y
(Yellow)
M
(Magenta)
C
(Cyan)
K
(Black)
* Set the value in increments of approximately 10, while checking the copy image until the optimum
value is obtained.
* Subcodes to be entered differ depending on the target density area. Refer to the table below to enter
the subcode for the area to be adjusted.
Subcode
0
1
2
Cautions after the adjustment
Nothing in particular
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
[05]
Original mode
code
05-7980
05-7981
User custom
05-7982
05-7983
Area where the density is
adjusted
Low-density area
Medium-density area
High-density area
2-79
2. Copier-specific Adjustments
Subco Recommend
de ed value
Set a value
0/1/2 larger than
128.
© 2008 TOSHIBA TEC CORPORATION All rights reserved
Accep
table
Default
range
value
0 to
128
255