Toshiba e-studio 2330c Imaging Manual page 38

(4) Press the [BASIC] button on the Control Panel. Select "TEXT" from among the original mode options.
* To have "TEXT" selected from among the original mode options by default, refer to procedure (1) in 2.8
To Eliminate Moiré.
After selecting the Text mode, copy and check the copy image quality.
If further image quality adjustments are still necessary, use the next procedure.
(5) Enter adjustment mode [05]. Decrease the values for codes [648], [649], [925], [7102] and [7103] to make
the text darker (improving faint text or thin lines).
Original mode
Text / Photo
Text
User custom
ACS / Black
Text/Photo
ACS / Black
Text
* Set the value in increments of approximately 1, while checking the copy image until the optimum value is
obtained.
After increasing the copy density, copy and check the copy image quality.
If further image quality adjustments are still necessary, use the next procedure.
(6) Enter adjustment mode [05]. Change the values for codes [590] to [592] and [7956] to [7959] to adjust the
gamma balance in each of medium- and high-density areas.
Original mode [05] code
Text / Photo
Text
Photo
Image smoothing
ACS / Black
Text/Photo
ACS / Black
Text
ACS / Black
Photo
* Set the value in increments of approximately 20, while checking the copy image until the optimum value is
obtained.
(Please be careful because the gradation (or density) of the medium-density area may exceed that of the
high-density area, depending on the set value.)
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
Recommended
[05] code
value
05-648
05-649
05-925
Set a value smaller
than 2.
05-7102
05-7103
Subcode
05-590
05-591
05-592
05-7956
1/2
05-7957
05-7958
05-7959
2-3
2. Copier-specific Adjustments
Acceptable
value range
0 to 4
Recommended Acceptable
value value range
Set a value larger
0 to 255
than 128.
© 2008 TOSHIBA TEC CORPORATION All rights reserved
Default
2
Default
128