Toshiba e-studio 2330c Imaging Manual page 66

(3) Enter adjustment mode [05]. Change the values for codes [7033], [7034], [7041] to [7044], [7048] and
[7049] to adjust the density level of the background.
Adjustment
Manual density
adjustment
Manual adjustment
* Set the value in increments of approximately 25, while checking the copy image until the optimum value is
obtained.
After adjusting the background density, copy and check the copy image quality.
If further image quality adjustments are still necessary, use the next procedure.
(4) Enter the adjustment mode [05]. Change the values for codes [7286] and [7287] to make the range
correction operation in the manual density mode fixed.
• The code to be set differs depending on the original mode (Text/Photo or Text). Select the [05] code for the
target original mode and change the value to "0".
Original mode
Text/Photo
Text
* Explanation for setting values
Setting Range correction
value
0
1
After adjusting the background peak, copy and check the copy image quality.
If further image quality adjustments are still necessary, use the next procedure.
e-STUDIO2330C/2820C/2830C/3520C/3530C/4520C
Original mode [05] code
Text/Photo 05-7041
Text 05-7042
Photo 05-7048
Image smoothing 05-7049
Text/Photo 05-7033
Text 05-7034
Photo 05-7043
Image smoothing 05-7044
Recommended
[05] code
05-7286
05-7287
operation
Fixed
Varied
2-31
2. Copier-specific Adjustments
Recommended
value
Set a value smaller
than 128.
Acceptable
value value range
0 0, 1
© 2008 TOSHIBA TEC CORPORATION All rights reserved
Accep
table
Default
value
range
0 to
128
255
Default
1