Table of Contents
Advertisement
iDEN 800 MHz Specifications
Model Number
Antenna connectors
Antenna impedance
Dimensions
Weight
Frequency
Passband Gain (nominal)
1
Power Output
2
Power output for single cell phone (uplink)
Power output for single received channel (downlink)
Noise Figure (typical downlink/uplink)
Isolation
Power Requirements
Notes:
1. Nominal gain is the maximum gain at any frequency in the passband.
2. The Manufacturer's rated output power of this equipment is for single carrier operation. For situations
when multiple carrier signals are present, the rating would have to be reduced by 3.5 dB, especially
where the output signal is re-radiated and can cause interference to adjacent band users. This power
reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the
device.
3301 East Deseret Drive, St. George, UT 84790
For additional Technical Support visit www.WilsonElectronics.com
Phone: 866-294-1660
www.twitter.com/WilsonCellular
or email at: tech@wilsonelectronics.com
Local: 435-673-5021
iDEN 800 MHz Specifications
5.7 x 4.2 x 1.5 inch (14.0 x 10.8 x 3.9 cm)
806-821 MHz / 851-866 MHz
3.5 dB nominal / 5 dB nominal
100-240 V AC, 50-60 Hz, 21 W
www.facebook.com/WilsonCellular
274080
N-Female
50 Ohms
1.27 lbs (0.544 kg)
70 dB Typical,
75 dB Maximum
806-824 MHz
34.0 dBm
26.0 dBm
> 90 dB
Fax: 435-656-2432
AIG #110995_iDEN800MHz_Rev2_11.22.11
Advertisement
Table of Contents
