Care And Cleaning; Mesh Grease Filters - Monogram ZV30 Owner's Manual

Care and Cleaning
Professional Range Hood
For your
safety
Pour votre
securit
Before servicing or cleaning unit, switch
power off at service panel and lock the service
disconnecting means to prevent power from
being switched on accidentallg. When the service
disconnecting means cannot be locked, securelg
fasten a prominent warning device, such as a
tag, to the service panel.
Avant de r6parer ou de nettoger votre appareil,
d_branchez le courant au niveau du panneau
de service et verrouillez les m6canismes de
d6branchement de service pour 6viter tout
branchement accidentel au courant. Si vous
ne pouvez pas verrouiller les m6canismes
de d6branchement de service, attachez
soigneusement un avertissement bien visible,
comme une 6tiquette, au panneau de service.
Mesh
grease
filters and
drip tray
{on some models)
Some models have 2 metal reusable grease
filters and drip trag.
The metal filters and drip trag trap grease
released bg foods on the cooktop. The filters also
help prevent flaming foods on the cooktop from
damaging the inside of the hood.
For this reason, the filters must ALWAYS be in
place when the hood is used. The grease filters
and drip trag should be cleaned everg 6 months,
or as needed.
To clean the drip tray, drain and wipe all excess
grease with a drg paper towel. Wash with hot
soapg water. Drg with a clean cloth.
To clean the grease filters, soak them and then
swish them around in hot water and detergent.
Don't use ammonia or ammonia products
because theg will darken the metal. Do not use
abrasives or oven cleaners. Light brushing can be
used to remove embedded dirt. Rinse,shake and
let them drg before replacing.
To remove:
Grasp the filter lock and pivot it open to release.
Pull the filter down and out. Remove both filters.
Grasp the drip trag, on both sides, bg the front
edge and carefullg lift it up and out.
To replace:
1. Place and seat the drip trag into the hood
track, making sure the rear tabs on the trag,
hook into the back slots in the hood track.
2. Place the bottom of the filter in the lower
hood rail.
3. Push the top of the filter back, open the filter
lock and snap it into place.
Grease Filters
Filter Locks
Drip Trag