Schwinn 270 Assembly Manual / Owner's Manual page 41

Nospeed/RPM reading, Check datacable integrity Allwires incable should beintact.Ifanyarecutor crimped,
Console d isplays " Please replace c able.
Pedal" e rror c ode
Check datacable Besurecable isconnected s ecurely a ndoriented properly. Small
connections/orientation latchonconnector should lineupandsnapintoplace.
Check magnet position Magnet should beinplace onpulley.
(requires shroud removal)
Check Speed Sensor ( re- Speed sensor s hould bealigned w ithmagnet andconnected t o
quires shroud removal) datacable. R ealign s ensor i fnecessary. Replace i fthereisany
damage tothesensor o rtheconnecting w ire.
Console s huts off(enters Check electrical (wall) Make sureunitis plugged intoa functioning wall o utlet.
sleep mode) w hileinuse outlet
Check connection atfront Connection should besecure andundamaged. Replace a dapter
ofunit or connection atunitifeither a redamaged.
Check datacable integrity Allwires inthecableshould beintact. I fanyarecutorcrimped,
replace c able.
Check datacable Besurecable isconnected s ecurely a ndoriented properly. Small
connections/orientation latchonconnector should lineupandsnapintoplace.
Reset m achine Unplug unitfromelectrical outlet f or3 minutes. Reconnect to
outlet.
Check magnet position Magnet should beinplace onpulley.
(requires shroud removal)
Check Speed Sensor ( re- Speed sensor s hould bealigned w ithmagnet andconnected t o
quires shroud removal) datacable. R ealign s ensor i fnecessary. Replace i fthereisany
damage tothesensor o rtheconnecting w ire.
Fanwill n otturnonor will Check datacable integrity Allwires incable should beintact.Ifanyarecutor crimped,
notturnoff replace c able.
Check datacable Besurecable isconnected s ecurely a ndoriented properly. Small
connections/orientation latchonconnector should lineupandsnapintoplace.
Reset m achine Unplug unitfromelectrical outlet f or3 minutes. Reconnect to
outlet.
Fanwill n otturnon,but Check forblockage o ffan Unplug unitfromelectrical outlet f or5 minutes. Remove m aterial
Console o perates fromfan.Ifnecessary, detach theConsole t o helpwithremoval.
Replace t heConsole i funable to remove b lockage.
Unitrocks/does n otsit Check leveler adjustment Adjust l evelers u ntil m achine i s level.
level
Check surface under unit Adjustment maynotbeabletocompensate forextremely uneven
surfaces. Move machine t olevel a rea.
Seat A ssembly s hifts
/ Hardware Check hardware that attaches Seat assembly, and fully tighten
squeaks when in use hardware.
Pedals loose/unit difficult Check pedal to crank con- Pedal should be tightened securely to crank. Be sure connection
to pedal nection is not cross threaded.
Check crank to axle con- Crank should be tightened securely to axle.
nection