ZN-BT662XE-MIR Installation Guide
4. INSTALLATION
Place the installation template that is provided in the package on the
1)
desired position of installation.
Drill four holes on the template and insert anchor blocks into the holes.
2)
Fasten the camera with screws.
Make sure the cables are properly connected to the camera.
3)
Adjust the camera to the desired angle by unscrew the joints by referring to
4)
the following pictures.
Adjust this joint to
install it on the wall
!
The camera may fall off the ceiling even after the proper installation and
mounting. To prevent any accident, make sure the ceiling is firm and stable
Caution
enough to support the camera. If any reinforcement is needed, consult with
your safety personnel and proceed with the installation.
01A.01
Tiling adjustment
Panning adjustment
8