Selecting Auto White Balance Settings - Cisco 5010 User Manual

Imaging Tab

Selecting Auto White Balance Settings

Figure 3-9 Auto White Balance Page
Place your mouse pointer over the Imaging tab.
Step 1
Step 2 Select White Balance from the drop-down menu.
Step 3 Select the Auto mode.
Step 4 Move the sliders to adjust the following settings in Auto mode:
•
•
•
If required, click the Factory Defaults button to reset the white balance to the factory default setting.
Step 5
Cisco Video Surveillance 5010/5011 Indoor Fixed HD IP Dome Camera User Guide
3-22
Red Gain Adjust: Adjusts the image output in the red range. Move the slider to the right to increase
the red level; move the slider to the left to decrease the red level. As you move the slider, you will
see the color change on your monitor. The auto range of adjustment is –1.0 to 1.0; the default setting
is 0 (zero).
Green Gain Adjust: Adjusts the image output in the green range. Move the slider to the right to
increase the green level; move the slider to the left to decrease the green level. As you move the
slider, you will see the color change on your monitor. The auto range of adjustment is –1.0 to 1.0;
the default setting is 0 (zero).
Blue Gain Adjust: Adjusts the image output in the blue range. Move the slider to the right to
increase the blue level; move the slider to the left to decrease the blue level. As you move the slider,
you will see the color change on your monitor. The auto range of adjustment is –1.0 to 1.0; the
default setting is 0 (zero).
Chapter 3 Operation
OL-22669-01