Video Mode Selection; Dip Switch Settings - Cisco TelePresence PrecisionHD 1080P 12x User Manual

Cisco TelePresence PrecisionHD Camera
Contents Introduction
The VISCA™/RS–232 control
protocol, cont...
NOTE: The information on this page applies to PrecisionHD
1080p 12X camera.

Video mode selection

The DIP switch selection has priority over the selection made by
the CAM_Video_Format command. If the DIP switch is set to
auto, the CAM_Video_Format setting will be used. If both are set
to auto, resolution will be controlled automatically by EDID.

DIP Switch settings

Switches are numbered 1 to 5. The VISCA column shows the
value that must be used when using the CAM_Video_Format
command.
NOTE: The DIP switches are only read by the SW at startup/
boot. So if the DIP switches are changed the camera must be
rebooted.
If an undefined mode is selected, the output will default to auto.
D14640.03 PrecisionHD 1080p-720p Camera User Guide TC4.0, November 2010.
© 2010 Cisco Systems, Inc. All rights reserved.
The physical interface Connecting the camera
DIP switch table
DIP Switch table for VISCA commands and video output formats
1 2 3 4 5
0 0 0 0 0
0 0 0 0 1
0 0 0 1 0
0 0 0 1 1
0 0 1 0 0
0 0 1 0 1
0 0 1 1 0
0 0 1 1 1
0 1 0 0 0
0 1 0 0 1
PrecisionHD 1080p 12X, underside
26
Video output formats
VISCA HDMI HD-SDI
x
Auto
*
0x0000 1080p25 1080p25
0x0001 1080p30 1080p30
0x0002 1080p50 720p50
0x0003 1080p60 720p60
0x0004 720p25 720p25
0x0005 720p30 720p30
0x0006 720p50 720p50
0x0007 720p60 720p60
0x0009
SW control
0 1
PrecisionHD Camera User guide
Daisy chaning Appendices Appendices
The table shows the different settings
available for the HDMI and the HD-SDI
outputs.
Auto: Camera negotiates format over
HDMI. HD-SDI tracks HDMI and defaults
to 1080p30 in absence of HDMI sync.
Software: Used when controlling
cameras using the VISCA protocol.
The DIP switches 1 to 5
www.cisco.com