Cisco 5010 User Manual page 14

In-Ceiling Installation
Connect the auto iris lens to the 4-pin connector located on the side of the camera. Pin connections
c.
for the iris drive connector are as follows:
Figure 2-1
3
1
Pin
1
2
3
4
Connect the wiring to the side of the back box:
Step 3
Plug the network cable into the RJ-45 network port on the side of the camera. If the network has no
a.
PoE, connect a 24 VAC Class 2 power supply to the 24 VAC power connector. Refer to
section on page 2-10
Connect the necessary wiring for alarms and relays (refer to
b.
information.)
Install the back box by compressing the spring clips and pushing the back box through the hole. Tighten
Step 4
the machine screws completely to secure the back box to the ceiling.
Figure 2-2
Step 5 Apply power to the camera. The camera will complete a configuration sequence; the green LED flashes
five times per second for approximately two minutes and then turns solid after the sequence is complete.
Note
Cisco Video Surveillance 5010/5011 Indoor Fixed HD IP Dome Camera User Guide
2-2
Lens Pin Connections
4
2
DC (AID) Auto Iris Lens
Control coil negative (–)
Control coil positive (+)
Drive coil positive (+)
Drive coil negative (–)
for wiring connections.
In-Ceiling Installation
If the camera is not connected to a DHCP server and DHCP is enabled, the configuration
sequence might take up to five minutes to complete.
Chapter 2
"Wiring" section on page 2-10
Installation
"Wiring"
more
OL-22669-01