Changing The Digital Processing Settings - Cisco 5010 User Manual

Imaging Tab

Changing the Digital Processing Settings

Figure 3-3 Digital Processing Page
Place your mouse pointer over the Imaging tab.
Step 1
Select General from the drop-down menu.
Step 2
Step 3 Select the mode: Manual or Auto. Auto is the default.
Step 4 Move the slider to the left or right to change the following settings:
•
•
•
Cisco Video Surveillance 5010/5011 Indoor Fixed HD IP Dome Camera User Guide
3-14
Sharpness Adjust/Sharpness: Controls the clarity of detail in a scene. Move the slider to the right
to increase the sharpness; move the slider to the left to decrease the sharpness. Increasing the
sharpness also increases the image noise. The auto range of adjustment is –100 to 100; the auto
default setting is 0 (zero). The manual range of adjustment is 0 to 100; the manual default setting is
50.
Saturation Adjust/Saturation: Controls how intense or vivid the colors are in a scene. Move the
slider to the right to increase the saturation level; move the slider to the left to decrease the saturation
level. The auto range of adjustment is –100 to 100; the auto default setting is 0 (zero). The manual
range of adjustment is 0 to 100; the manual default setting is 50.
Contrast Adjust/Contrast: Controls gradations between the darkest and lightest portions of the
scene. Move the slider to the right to increase the contrast; move the slider to the left to decrease the
contrast. The auto range of adjustment is –100 to 100; the auto default setting is 0 (zero). The manual
range of adjustment is 0 to 100; the manual default setting is 50.
Chapter 3 Operation
OL-22669-01