Video Mode Selection; Dip Switch Settings; Dip Switch Table - Cisco PrecisionHD 1080p12x User Manual

Cisco TelePresence PrecisionHD Camera
Contents Introduction
The VISCA™/RS–232 control
protocol, cont...
NOTE: The information on this page only applies to PrecisionHD
Camera 1080p12x.

Video mode selection

The DIP switch selection has priority over the selection made
by the CAM_Video_Format command. If the DIP switch is set to
auto, the CAM_Video_Format setting is used. If both are set to
auto, resolution is controlled automatically by EDID.

DIP Switch settings

The switches are numbered 1 to 5. The VISCA column shows
the value that must be used when using the
command.
NOTE: The DIP switches are only read by the software at startup/
boot. Therefore if the DIP switches are changed the camera
must be rebooted.
If an undefined mode is selected, the output defaults to auto.
D14640.12 Cisco Telepresence PrecisionHD Camera User Guide TC6.2, August 2013.
The Physical Interface

DIP switch table

DIP Switch table for VISCA commands and video output formats
1 2
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
CAM_Video_Format
0 1
0 1
PrecisionHD 1080p12x, from below
Connecting the Camera Daisy Chaining
3 4 5 VISCA HDMI
x
0 0 0 Auto*
0x0000 1080p25
0 0 1
0x0001 1080p30
0 1 0
0x0002 1080p50
0 1 1
0x0003 1080p60
1 0 0
0x0004 720p25
1 0 1
0x0005 720p30
1 1 0
0x0006 720p50
1 1 1
0x0007 720p60
0 0 0
0x0009
0 0 1 SW control
34
Video Output Format
The table shows the different settings avail-
able for the HDMI and the HD-SDI outputs.
HD-SDI
Auto: Camera negotiates format over
HDMI. HD-SDI tracks HDMI and defaults
to 1080p30 in absence of HDMI sync.
1080p25
Software: Used when controlling cameras
1080p30
using the VISCA protocol.
720p50
720p60
720p25
720p30
720p50
720p60
The DIP switches 1 to 5
0 1
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.
User Guide
Appendices Appendices