Dual Top - Four-Door Models - If Equipped; Removing The Soft Top - Four-Door Models - Jeep Wrangler 2015 Operating Information Manual

DUAL TOP — FOUR-DOOR
MODELS — IF EQUIPPED
If your vehicle is equipped with a Dual Top, you
must remove one of the tops from the ve-
hicle. If the soft top is removed, the pivot
brackets must also be removed from the
sport bar. The soft top was installed at the
factory for shipping purposes only. The soft top
and the hard top are to be used indepen-
dently. Removal is mandatory to prevent any
possible wear and tear on the soft top. Your
vehicle warranty will not cover damage resulting
from both tops remaining on the vehicle at the
same time for extended periods of time.
Removing The Soft Top —
Four-Door Models
1. Locate and remove the two boxes that con-
tain the following items:
• Right and left door frames
• Six door frame attachment knobs
• Right and left quarter windows
• Rear window
116
• Two rear window roll up straps
• Two Sunrider® secure straps (if equipped)
• Two rear swing gate brackets
2. Remove the hard top. Refer to "Freedom
Top™ Three-Piece Modular Hard Top —
Front/Rear Panel Removal" in this section.
3. Ensure the tether strap is secure to the pivot
bracket. Unbutton the side bow tether strap
(both sides).
4. Using the plastic reinforcement as a handle,
slide the tether strap up the side bow (both
sides).
5. The tether strap must be hooked onto the
pivot bracket prior to removal of soft top from
vehicle (both sides).