Installing The Soft Top — Two-Door Models - Jeep Wrangler 2015 Operating Information Manual

• Rear window
• Two rear window roll up straps
• Two Sunrider® secure straps (if equipped)
• Two rear swing gate brackets
2. Remove the hard top. Refer to "Freedom
Top™ Three-Piece Modular Hard Top —
Front/Rear Panel Removal" in this section.
3. Remove the soft top bow assembly pivot
bracket screws (two per side) using a #T30
Torx® head driver.
114
4. Disconnect the knuckles from the left and
right metal pivot brackets. Remove the soft
top from the vehicle and store in a clean, dry
location.
NOTE:
To aid in disconnecting the knuckles, you
may carefully tap on the knuckles using a
rubber mallet.
5. Unzip the zipper on the sport bar cover to
expose the pivot brackets. Remove the brack-
ets using a #T30 Torx® head driver. Recover
and re-zip the sports bar cover. Store the pivot
brackets and screws in a safe place.
6. Reinstall the hard top. Refer to "Freedom
Top™ Three-Piece Modular Hard Top —
Front/Rear Panel Installation" in this section.
Installing The Soft Top — Two-Door
Models
NOTE:
The following procedures are for first time
set up only. For future soft top procedures,
refer to "Soft Top" in this section.
1. Locate and remove the following items prior
to hard top removal:
• Right and left door frames
• Door frame attachment knobs (four for
two-door models, six for four-door models)
• Right and left quarter windows
• Rear window
2. Remove the hard top. Refer to "Freedom
Top™ Three-Piece Modular Hard Top —
Front/Rear Panel Removal" in this section.