Table of Contents
Advertisement
Jack Warning Label
CAUTION!
Do not attempt to raise the vehicle by jacking
on locations other than those indicated in the
Jacking Instructions for this vehicle.
1. Remove the spare tire, jack and tools from
the stored location.
2. Loosen (but do not remove) the wheel lug
nuts by turning them to the left one turn while
the wheel is still on the ground.
3. Assemble the jack and jacking tools. Con-
nect the jack handle driver to the extension,
then to the lug wrench.
4. Operate the jack from the front or the rear of
the vehicle. Place the jack under the axle
tube, as shown. Do not raise the vehicle
until you are sure the jack is fully en-
gaged.
Rear Jacking Location
Front Jacking Location
5. Raise the vehicle by turning the jack screw
clockwise. Raise the vehicle only until the tire
just clears the surface and enough clearance
is obtained to install the spare tire. Minimum
tire lift provides maximum stability.
WARNING!
Raising the vehicle higher than necessary
can make the vehicle less stable and cause
a collision. It could slip off the jack and hurt
someone near it. Raise the vehicle only
enough to remove the tire.
293
Advertisement
Chapters
Table of Contents
