Installing The Soft Top - Two-Door Models - Jeep Wrangler 2014 Owner's Manual

192 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
5. Unzip the zipper on the sport bar cover to expose the
pivot brackets. Remove the brackets using a #T30
Torx® head driver. Recover and re-zip the sports bar
cover. Store the pivot brackets and screws in a safe
place.
6. Reinstall the hard top. Refer to "Freedom Top™ Three-
Piece Modular Hard Top — Front/Rear Panel Instal-
lation" in this section.
Installing The Soft Top — Two-Door Models
NOTE: The following procedures are for first time set up
only. For future soft top procedures, refer to "Soft Top" in
this section.
1. Locate and remove the following items prior to hard
top removal:
• Right and left door frames
• Door frame attachment knobs (four for two-door
models, six for four-door models)
• Right and left quarter windows
• Rear window
2. Remove the hard top. Refer to "Freedom Top™ Three-
Piece Modular Hard Top — Front/Rear Panel Re-
moval" in this section.
3. Install the door frames. Refer to "Door Frame" in this
section.
4. If the soft top has been removed, follow these steps to
reinstall the soft top. If the soft top is on the vehicle,
proceed to step #5.
a. If the pivot brackets have been removed, unzip the
sport bar covers and attach the pivot brackets to the
sports bar with the four screws that were removed
using a #T30 Torx® head driver. Re-cover and
re-zip the sport bar covers.