Table of Contents
Advertisement
74 GETTING TO KNOW YOUR VEHICLE
Installing The Soft Top — Two Door Models
NOTE: The following procedures are for first time set up
only. For future soft top procedures, refer to "Soft Top" in
this section.
1. Locate and remove the following items prior to hard top
removal:
• Right and left door frames
• Door frame attachment knobs (four for two-door mod-
els, six for four-door models)
• Right and left quarter windows
• Rear window
2. Remove the hard top. Refer to "Freedom Top Three-
Piece Modular Hard Top — Front/Rear Panel Removal"
in this section.
3. Install the door frames. Refer to "Door Frame" in this
section.
4. If the soft top has been removed, follow these steps to
reinstall the soft top. If the soft top is on the vehicle,
proceed to step #5.
a. If the pivot brackets have been removed, unzip the
sport bar covers and attach the pivot brackets to the
sports bar with the four screws that were removed
using a #T30 Torx head driver. Re-cover and re-zip
the sport bar covers.
b. Lay the soft top into the rear of the vehicle with the
bows pointing forward and the curved portion of the
bows facing upward.
c. Reattach the knuckles onto the metal pivot brackets.
NOTE: To aid in reattaching the knuckles, you may care-
fully tap on the knuckles using a rubber mallet.
d. Screw the pivot screws back into place using a #T30
Torx head driver. Secure them until they are snug,
being careful not to cross-thread the screws or over-
tighten.
Advertisement
Table of Contents
