Self Diagnostic Codes - Kyocera FS-3040MFP+ Service Manual

(2) Self diagnostic codes

Code Contents
0030 FAX control PWB system
error
Processing with the fax
software was disabled due
to a hardware problem.
0070 FAX control PWB incom-
patible detection error
Abnormal detection of FAX
control PWB incompatibil-
ity In the initial communica-
tion with the FAX control
PWB, any normal commu-
nication command is not
transmitted.
0100 Backup memory device
error
0120 MAC address data error
For data in which the MAC
address is invalid.
0130 Backup memory read/
write error (main PWB)
0140 Backup memory data
error (main PWB)
0150 Engine PWB EEPROM
error
Detecting engine PWB
EEPROM communication
error.
0170 Billing counting error
A checksum error is
detected in the main and
engine backup memories
for the billing counters.
Causes
Defective FAX con- Replace the fax control PWB
trol PWB.
rect operation
Defective FAX soft- Install the fax software.
ware.
Defective FAX con- Replace the fax control PWB
trol PWB.
rect operation
Defective flash Replace the main PWB and check for correct
memory. operation (see page 1-5-34).
Defective main Replace the main PWB and check for correct
PWB. operation (see page 1-5-34).
Defective flash Replace the main PWB and check for correct
memory. operation (see page 1-5-34).
Defective engine Replace the engine PWB and check for correct
PWB. operation (see page 1-5-30).
Defective flash Replace the main PWB and check for correct
memory. operation (see page 1-5-34).
Defective main Replace the main PWB and check for correct
PWB. operation (see page 1-5-34).
Defective flash Replace the main PWB and check for correct
memory. operation (see page 1-5-34).
Defective main Replace the main PWB and check for correct
PWB. operation (see page 1-5-34).
Improper installa- Check the installation of the EEPROM and
tion engine PWB remedy if necessary.
EEPROM.
Defective engine Replace the engine PWB and check for correct
PWB. operation (see page 1-5-30).
Device damage of Contact the Service Administrative Division.
EEPROM.
Data damage of Contact the Service Administrative Division.
EEPROM.
Defective PWB. Replace the main PWB or the engine PWB and
check for correct operation (see page 1-5-34).
1-4-6
Check procedures/
corrective measures
and check for cor-
. (see page 1-5-42).
and check for cor-
. (see page 1-5-42).
2MF/2MG