Self Diagnostic Codes - Kyocera FS-C5150DN Service Manual

(2) Self diagnostic codes

If the part causing the problem was not supplied, use the unit including the part for replacement.
Code Contents
0100 Backup memory device
error
0120 MAC address data error
For data in which the MAC
address is invalid.
0130 Backup memory read/write
error (main PWB)
0140 Backup memory data error
(main PWB)
0150 Engine PWB EEPROM error
Detecting engine PWB
EEPROM communication
error.
0170 Billing counting error
A checksum error is detected
in the main and engine
backup memories for the bill-
ing counters.
0600 Expanded memory (DIMM)
installing error
The expansion memory mod-
ules (DIMM) are not correctly
mounted.
0610 Expanded memory (DIMM)
error
The expansion memory mod-
ules (DIMM) mounted on the
main PWB does not operate
correctly.
Causes
Defective flash Replace the main PWB and check for cor-
memory. rect operation (see page 1-5-29).
Defective main Replace the main PWB and check for cor-
PWB. rect operation (see page 1-5-29).
Defective flash Replace the main PWB and check for cor-
memory. rect operation (see page 1-5-29).
Defective engine Replace the engine PWB and check for cor-
PWB. rect operation (see page 1-5-26).
Defective flash Replace the main PWB and check for cor-
memory. rect operation (see page 1-5-29).
Defective main Replace the main PWB and check for cor-
PWB. rect operation (see page 1-5-29).
Defective flash Replace the main PWB and check for cor-
memory. rect operation (see page 1-5-29).
Defective main Replace the main PWB and check for cor-
PWB. rect operation (see page 1-5-29).
Improper installa- Check the installation of the EEPROM and
tion engine PWB remedy if necessary.
EEPROM.
Defective engine Replace the engine PWB and check for cor-
PWB. rect operation (see page 1-5-26).
Device damage of Contact the Service Administrative Division.
EEPROM.
Data damage of Contact the Service Administrative Division.
EEPROM.
Defective PWB. Replace the main PWB or the engine PWB
and check for correct operation (see page 1-
5-29, 1-5-26).
Improper installa- Check the installation of the expanded mem-
tion expanded ory (DIMM).
memory (DIMM).
Defective Replace the expanded memory (DIMM) and
expanded memory check for correct operation (see page 1-2-
(DIMM). 10).
Defective main Replace the main PWB and check for cor-
PWB. rect operation (see page 1-5-29).
1-4-7
Check procedures/
corrective measures
2KT/2KV