1-5-8 Fuser section
(1) Detaching and refitting the fuser unit
Procedure
1. Draw the rear unit.
2. Insert a flat-blade screwdriver to push
the fuser lock (gray colored) on the rear
unit and the fuser unit is separated from
the rear unit (rails).
Do it both ends of the rear unit.
3. Check or replace the fuser unit and refit
all the removed parts.
Place the fuser unit on the rear unit
(rails) and push the fuser lock so that
the fuser lock catches the fuser unit.
Do it for the both ends of the fuser unit.
NOTE:
When the periodic maintenance
(replacing the maintenance kit, see
page 2-4-4), perform maintenance
mode.:
U251 Clearing the maintenance count
(see page 1-3-14)
Fuser unit
Rail
Flat-blade
Fuser lock
screwdriver
(gray colored)
1-5-29
Rail
Rear unit
Fuser lock
(gray colored)
Figure 1-5-46
2MF/2MG
Flat-blade
screwdriver