Kyocera FS-3040MFP+ Service Manual page 167

18. Remove one connector.
19. Remove seven screws and then
remove the power source PWB.
20. Check or replace the power source
PWB and refit all the removed parts.
Note:
While assembling the rack component,
align the guiding holes on either the
upper cover rack and the front cover
rack with each other.
Screw
Connector
Heat sink plate
Screws
Screws
Rack cover
Guiding holes
Upper cover rack
1-5-41
Screw
Power source
PWB plate
Figure 1-5-62
Front cover
rack
Figure 1-5-63
2MF/2MG
Screw
Power source
PWB
Guiding holes