Mks-2010/2015/2017 Front Panel - Sony MFS-2000-C Operation Manual

• For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to the
following ports.
- SWITCHER DATA connector
- DME DATA (Digital Multi Effects Data) connector
- SWITCHER CTRL (Switcher control) connector

MKS-2010/2015/2017 Front Panel

a "Memory stick" slot
A slot to insert "Memory Stick". Used to install software
and to save and read data such as snapshot and setup data.
See "About "Memory Stick"" (page 17) for more
information about "Memory Stick".
b "Memory stick" status indicator
Data is being read from or written to a "Memory Stick"
when the status indicator is lit or flashing.
Note
Do not power the unit off or remove a "Memory Stick"
when the status indicator is lit or flashing.
c POWER A and B status indicators
The status indicators light in green when the unit is
powered on.
The POWER B status indicator does not light when the
optional HK-PSU11 Power Supply Unit is not supplied in
the factory configuration.
1"Memory stick" slot
2"Memory stick" status indicator
3POWER A and B status indicators
A POWER
4USB connector
When the HK-PSU11 is installed, operation can be
continued as long as the POWER B status indicator is lit.
Caution
Contact a Sony service or marketing representative
regarding installation of the HK-PSU11.
Note
If the status indicators do not light even though the AC
power cord is connected, there may be failure in the unit.
Disconnect the AC power cord and contact a Sony service
or marketing representative.
d USB connector (USB Type A)
Connect a mouse, keyboard, pen tablet or other device
with a USB interface.
Note
Contact a Sony service or marketing representative for
more information about connectable devices.
- DME CTRL (Digital Multi Effects Control)
connector
- FM DATA connector
Follow the instructions for the above ports.
B
Location and Function of Parts
11