Mfs-2000 Rear Panel - Sony MFS-2000-C Operation Manual

MFS-2000 Rear Panel

1REF IN connectors
1
8 1
9
18
1
qjIN 1 to 16 connectors
a REF IN (reference signal input) connectors (BNC
type)
If you with to synchronize this unit to an external reference
signal, input the reference signal. For an HDTV system,
input an HD tri-level sync signal, black burst signal, or
analog sync signal. For an SDTV system, input a black
burst signal or analog sync signal.
The two connectors have a loop-through configuration.
Signal input to one connector can be output from the other
connector. If you will not be using the loop-through
output, be sure to terminate the unused connector with the
supplied 75Ω terminator.
b REF OUT (reference video output) connector
(BNC type)
Output HD3 signals for HDTV and analog sync signals for
SDTV.
2REF OUT connector
3SWITCHER DATA connector
4DME DATA connector
5SWITCHER CTRL connector
6DME CTRL connector
7TERMINAL connector
8EDITOR connector
9SERIAL TALLY connector
TERMINAL
REF OUT DATA CTRL
EDITOR
REF IN DATA CTRL SERIAL TALLY
IN
2 3 4 5 6 7 8 1
IN
2 3 4 5 6 7 8 1
I.LINK S400
FM DATA FM DEVICE
qgOUT 1 to 8 connectors
qhFM DATA connector
0GPI connector
qaTally connector
TALLY
A
GPI
OUT
- AC IN
B
2 3 4
OUT
U
- AC IN
2 3 4
C
qd-AC IN A, B, C connectors
qfFM DEVICE connector
c SWITCHER DATA connector (RJ-45)
Connect to an Ethernet switch*.
The MFS-2000 System is connected in the same way to the
Ethernet switch to form a network for exchange of signals
between the devices. This network is used primarily for
exchange of various types of data (setup data, snapshots,
etc.).
* For information about Ethernet switches that can be used in an MFS-2000
system, contact your Sony service representative.
For more information about Ethernet switch connectors,
see "MFS-2000 System Configuration" (page 14).
For detailed information about setting up the Ethernet
switch, refer to the documentation supplied with the
Ethernet switch.
qsU terminal
Location and Function of Parts
9