Exchanging Button Labels; Adjusting Fader Torque - Sony MFS-2000-C Operation Manual

Exchanging Button
Labels
A button top puller is supplied with the control panel.
After changing a pattern assigned to a numeric button, you
can use the following procedure to exchange the button
label.
1
Write the new pattern on one of the supplied exchange
labels.
2
Grip the holes on the button sides with the supplied
button top puller and remove the button.
3
Reverse the button, grasp the outer sides of the cap
with the button puller, and remove the old label.
4
Remove the old label and insert the new label.
5
Replace the button cap.
6
Replace the button in its original location.
2

Adjusting Fader Torque

You can adjust faders without removing them from the
center control panel or operation modules.
Proceed as follows to adjust faders.
1
2
3
Fader lever
Pull the fader lever to an upright position between the
two holes on the fader cover.
Insert a hexagonal screwdriver or a hexagonal wrench
(4 mm sides) into one or both of the holes and rotate
to adjust the torque.
Rotate clockwise:
Fader lever operation becomes firmer.
Rotate counterclockwise:
Fader lever operation becomes freer.
Exchanging Button Labels / Adjusting Fader Torque
Hexagonal wrench
15