Mks-2010/2015/2017 Rear Panel - Sony MFS-2000-C Operation Manual

MKS-2010/2015/2017 Rear Panel

A
a - AC IN (AC power input) A and B connectors
(3-pin)
Connect to 100 to 240 V AC power supply with the
optional AC power cords.
There is not B connector when the optional HK-PSU11
Power Supply Unit is not installed.
Caution
Contact a Sony service or marketing representative
regarding installation of the HK-PSU11.
b GPI (General Purpose Interface) connector
(D-sub 25-pin)
Connect to external devices for input and output of trigger
signals. Up to eight inputs and eight outputs are possible,
with input and output conditions set on the control panel.
12
Location and Function of Parts
1 - AC IN A and B connectors
U
EXT DISPLAY DATA DEVICE
8DEVICE connector
9DATA connector
0EXT DISPLAY connector
qaU terminal
EDITOR PANEL REF IN REMOTE CTRL PERIPH
3PERIPH connector
4CTRL connector
5REMOTE connector
6REF IN connectors
7EDITOR PANEL connector
c PERIPH (peripheral) connector (RJ-45)
Connect to the DCU-8000 Device Control Unit Pack with
a cross cable to enable communications with the DCU-
8000.
Note
An Ethernet switch is required to connect two or more
DCU-8000 Device Control Units.
GPI
2GPI connector