Table of Contents
Advertisement
500ML Lighting Control Console
Operation Guide
• Snap Time - This is the time after all parameters that are set to be a "Snap-Channel" (in the fixture library) will
snap to their new value.
Note: A Next Time of 0 (zero) sets the cuelist to wait for a "Manual Go" command if the Run Mode is set to Auto,
Timecode, or if a Master Speed Fader controls cuelist timings.
Edit Cuelist Window
To open the Edit Cuelist Window as shown on
Figure
224, type [EDIT] [CUELIST], followed by the ID of the cuelist
you would like to edit the options of - i.e., [1]. Finish the command by pressing [ENTER].
Alternatively, you may use the Cuelist Pool window to select the cuelist by pressing the [CUELIST] key while
holding down the [EDIT] key. Select the cuelist you would like to edit or just press [EDIT] and select the appropriate
cuelist on the external monitor.
Figure 224: Edit Cuelist Window Example
The Edit Cuelist window consists of two different tabs - Basic and Timing Setup. The Basic tab contains all cuelist
configuration options. The Timing Setup tab contains cue timing options.
Note: All options in the Edit Cuelist window will be applied directly without pressing the OK Button.
Saving Options as Default
Specified options may be saved as default for new cuelists by pressing the Save Default button.
Loading Options from Default
Cuelist options may be loaded from the default state by clicking the Load Default button.
Show Cuelist Button
The Show Cuelist button may be used to open up the Cuelist View window for this cuelist.
Altering Cuelist Options
In order to alter Cuelist settings like Off-Time, Priority, Playback order, etc, you need to open the Edit Cuelist
window as described in
"Edit Cuelist Window" on page
120.
Basic Setup Tab
Go Trigger
The Go Trigger field defines how a Cuelist will be run. The default option is Auto.
1 2 0
Programming
Advertisement
Table of Contents
