Table of Contents
Advertisement
500ML Lighting Control Console
Operation Guide
Figure 217: Delete Cues from Cuelist Window
Loading Cues to the Programmer
Sometimes it is desirable to load a complete cue into the programmer to edit it. To do so, press the [LOAD] key on the
keypad. Now select the appropriate cuelist by the either a master's
(Figure 196 on page
109) Play [] or Pause / Back
Key [❚ ❚], or by selecting the cuelist in a Cuelist Pool Window.
If the Cuelist Pool window is not yet shown, keep the [LOAD] key pressed while pressing the [CUELIST] button on
the keypad.
You may also use the command line approach by, press the [LOAD] key followed by the [CUELIST] key. Type the
number of the cuelist you would like to load a cue from in - i.e., [1]. Now press [ENTER] to execute the command
(Figure
218).
Figure 218: Command Line Interface - Load Cuelist
A window will be opened asking you to select the Cue to be loaded. See
Figure 219
for more details. Click on Load
after selecting the Cue from the list.
Figure 219: Load Cue to Programmer Window
117
Cuelists
Advertisement
Table of Contents
