Table of Contents
Advertisement
500ML Lighting Control Console
Operation Guide
Setting the MIDI Note, Program or Control Change
The Midi Note / Program Change / Control Change defines which
MIDI Note, Program Change or Controller Event will be used for this
trigger. You may also put the console into a Learn mode that causes it
to listen to the MIDI Input and select the appropriate command and
channel number automatically (based on the last received MIDI
command). To enable the Learn Mode, click on the Learn On / Off
button.
Setting MIDI Channel
Should you wish to have a trigger only react to a specific MIDI channel, select it from the MIDI Channel Group Box.
By default, all channels are valid for a trigger. If the Learn function is used, the console will also learn the appropriate
MIDI channel.
MIDI Trigger Setup Window (Step 2 of 2 - Target Selection)
The Midi Trigger - Target Setup window is used to define what the previously added Midi Source will trigger. When
you are done, press the OK button to close the wizard.
Figure 261: MIDI Input Trigger Setup Step 2/2
Item Type
This will select the type of the Item that will be triggered by the previously defined
MIDI Command. Actions and Targets possible are dependent on the trigger type
and MIDI Command type. In General, the following Item Types are available for
the different triggers:
On / Off Triggers
On Off Triggers are provided by Note On / Off events and Control Changes. With Control Changes, the On portion of
the command will be issued when the Value is above 50% (For MIDI, this would be > Value 64), the Off is issued
when the value falls below 64 (or 50%). Refer to
"On / Off Triggers by Item Type" on page 142
for available types.
141
Setting Inputs and Outputs
Advertisement
Table of Contents
