Table of Contents
Advertisement
500ML Lighting Control Console
Operation Guide
Naming a Cuelist
Assigning Names using Cuelist Pool Window
Hit the [CUELIST] key while holding down the [ASSIGN] key. The Cuelist Pool window will be shown. The
command line will still read Assign. Now, press the [ASSIGN] key again. The command line will now read Name.
Now select the Cuelist you wish to rename from within the Preset Pool Window.
Assigning Names using Command Line Interface
You may use the command line approach by typing [ASSIGN] [ASSIGN] (the command line will read Name). Then
press the [CUELIST] key, followed by the Cuelist ID, in this case [12]. Hit [ENTER] to complete the command.
Please note you may also rename multiple Cuelists at once by using the [THRU], [+] and [-] modifier keys to further
extend your selection.
The Enter Cuelist Name window will appear
(Figure
200).
Figure 200: Enter Cuelist Name Window - Keyboard
Copying Cuelists
Copying Cuelists using the Cuelist Pool Window
Press and hold the [COPY] key while holding down the [CUELIST] key. The Cuelist Pool window will be shown.
Now select the cuelist you would like to copy, followed by the destination Pool Item.
To copy a cuelist shown on the external monitor, just press [COPY]. Select the source cuelist followed by the
destination cuelist from the external monitor's Cuelist Pool.
Copying Cuelists using the Command Line Interface
You may copy Cuelists using the command line approach by pressing [COPY]. Then hit the [CUELIST] key,
followed by the source Cuelist ID, in this case [1]. Now enter the destination Cuelist ID, ie [24]. Hit [ENTER] to
complete the command.
111
Cuelists
Advertisement
Table of Contents
